Baracoda Barcode Reader Manual do Utilizador descarregar pdf (Página 7)

RoadRunners BRR-L Programming guide May 2006

For example: to set the current time at 16th May 2007, 3.25 pm, the user will scan:

- “Set Timestamp” label,

- “0” label,

- “7” label,

- “0” label,

- “5” label,

- “1” label,

- “6” label,

- “1” label,

- “5” label,

- “2” label,

- “5” label,

- “0” label,

- “end of config” label.

2.4 Reading Mode

• In trigger mode, pressing the trigger will activate the beam.

• The Aiming trigger mode has been developped for users who need to scan barcodes very close

each others and they have to be sure to always read the corect one. Once in this mode, in order

to read a barcode user will have to press the trigger twice. Pressing it the first time will switch on

the beam but will not switch on the decoder (thus allowing user to aim at the correct barcode)

while pressing the trigger the second time will activate the decoder thus allowing the

RoadRunners to actually decode the barcode.

• In autoscan mode the beam will be continuously on

• In Smart Autoscan, for a battery power consumption optimisation issue, the scanner will be

continously flashing.

Trigger (*)

\VT\VT\FNC4d\NUL\SOH\NUL\FF\FF

trigger

Aiming Trigger Mode

\VT\VT\FNC4d\NUL\STX\EOT\LF\FF\FF

Aiming Trigger Mode

Autoscan

\VT\VT\FNC4d\NUL\SOH\ETX\FF\FF

autoscan

Smart Autoscan

\VT\VT\FNC4d\NUL\SOH\SOH\FF\FF

intelligent autoscan

1 2 3 4 5 6 7 8 9 10 11 12 ... 28 29

Sem comentários

Baracoda Barcode Reader Manual do Utilizador Página 7